You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
Battery charging using motor inductance by eptv on Sun, 2020-04-26 07:44 |
by eptv Sun, 2020-04-26 07:44 |
General discussion | ||
|
I'm trying a VESC in a RC car, but need help. by RandomloserDK on Sun, 2020-11-22 22:55 |
2 |
by RandomloserDK Tue, 2020-11-24 01:14 |
General discussion | |
|
Flipsky broken off USB ports by mnchvgs79 on Fri, 2021-06-25 20:25 |
by mnchvgs79 Fri, 2021-06-25 20:25 |
General discussion | ||
|
Getting started with bus control of the VESC by Invert on Mon, 2018-05-21 12:04 |
3 |
by PM Thu, 2018-05-31 18:38 |
General discussion | |
|
Question about UARTs by melluh on Sun, 2021-06-13 22:50 |
1 |
by vadicus Mon, 2021-06-14 01:15 |
General discussion | |
|
How to tune BLDC delay mode by Torbjorn on Tue, 2022-11-15 13:21 |
by Torbjorn Tue, 2022-11-15 13:21 |
General discussion | ||
|
Touchy ADC Connector by ebikerevolution on Thu, 2018-05-10 00:40 |
1 |
by Roger Wolff Thu, 2018-05-10 22:08 |
General discussion | |
|
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere on Fri, 2022-10-28 21:02 |
by sivanhere Fri, 2022-10-28 21:02 |
General discussion | ||
|
Updated VESC 6 schematic request by ma-j-sterelektron on Mon, 2019-03-25 08:43 |
3 |
by Roby_88 Thu, 2022-08-04 12:43 |
General discussion | |
|
PAS 3-wire sensor : possible to check a digital input under VESC-toool? by marc426 on Wed, 2021-10-27 00:26 |
6 |
by velolac Thu, 2021-11-25 20:09 |
General discussion | |
|
75200 vesc by Zander rowley on Tue, 2021-10-12 21:53 |
1 |
by Zander rowley Tue, 2021-10-12 21:56 |
General discussion | |
|
Motor amps higher than batt amps by minim on Sat, 2019-07-06 22:42 |
1 |
by Stupidspencer Mon, 2019-09-09 18:57 |
General discussion | |
|
Voltage variation and speed by bdesvaux on Mon, 2022-05-16 12:22 |
1 |
by frank Mon, 2022-05-16 20:52 |
General discussion | |
|
Motor draws current (up to 120 A), but doesn't turn by Heimfried on Sun, 2020-03-01 22:21 |
by Heimfried Sun, 2020-03-01 22:21 |
General discussion | ||
|
Controlling Servo via VESC and PPM by bruchpilot123 on Wed, 2020-09-23 13:26 |
1 |
by jarryc Sun, 2021-05-02 01:25 |
General discussion | |
|
Getting IMU Data over UART by Mido on Wed, 2021-04-21 12:30 |
5 |
by Igor Shapovalov Mon, 2023-03-13 14:49 |
General discussion | |
|
Flipsky 4.20 FOC settings Not Saving by erwinramos1010 on Mon, 2022-09-05 15:22 |
2 |
by wjpremerlani Sat, 2022-09-24 01:05 |
General discussion | |
|
More than 1A spike from the 5V 1A port of the VESC 6 HP by onluckyy on Thu, 2023-07-27 17:15 |
by onluckyy Thu, 2023-07-27 17:15 |
General discussion | ||
|
How to select COM port by Heimfried on Mon, 2020-05-04 22:23 |
3 |
by Heimfried Wed, 2020-06-10 11:55 |
General discussion | |
|
Install VESC on ubuntu 18.04 bionic by rest_vesc_001 on Tue, 2020-12-08 07:32 |
by rest_vesc_001 Fri, 2020-12-11 15:15 |
General discussion |
Pages
