You are here
Active forum topics
Primary tabs
| Topic |
Replies |
Last post | Forum | |
|---|---|---|---|---|
|
DRV Fault at high load by mikoyas on Sat, 2020-06-13 15:43 |
by mikoyas Sat, 2020-06-13 15:43 |
General discussion | ||
|
USB-serial_no ports show up at all by Josiah Eberharter on Tue, 2024-07-23 05:45 |
by Josiah Eberharter Tue, 2024-07-23 05:45 |
VESC Tool | ||
|
75300 r2 v5.3 by Oscarmanassan on Tue, 2022-09-27 14:23 |
by Oscarmanassan Tue, 2022-09-27 14:23 |
VESC Firmware | ||
|
Flipsky VX4 screen delays when full throttle by newbie on Mon, 2024-07-01 16:47 |
by newbie Mon, 2024-07-01 16:47 |
Third Party Hardware | ||
|
Using vesc between many motors by EliProtiva on Tue, 2021-02-16 05:32 |
by EliProtiva Tue, 2021-02-16 05:32 |
General discussion | ||
|
Simulating controller accurately by TechAUmNu on Fri, 2019-08-16 15:35 |
by TechAUmNu Fri, 2019-08-16 15:35 |
General discussion | ||
|
foc detection params by stefann on Mon, 2020-04-13 00:07 |
by stefann Mon, 2020-04-13 00:28 |
VESC Tool | ||
|
vesc dual 6.6 plus problem firmware by Szergej on Mon, 2020-08-24 21:32 |
by Szergej Mon, 2020-08-24 21:32 |
VESC Firmware | ||
|
no effect on set erpm/speed limit by xenon321 on Sat, 2021-04-24 20:43 |
by xenon321 Sun, 2021-04-25 16:53 |
VESC Tool | ||
|
ADC2 - I just can’t figure it out by mnchvgs79 on Fri, 2023-10-27 02:21 |
by mnchvgs79 Fri, 2023-10-27 02:21 |
VESC Firmware | ||
|
Motors wont turn independently by huffauden19 on Mon, 2020-11-30 06:24 |
by huffauden19 Mon, 2020-11-30 06:24 |
VESC Tool | ||
|
Fsesc 4.20 plus aiuto by sandrino on Sun, 2023-01-22 20:50 |
by sandrino Mon, 2023-01-23 21:13 |
Third Party Hardware | ||
|
Power by kuba12 on Sun, 2021-03-14 20:46 |
by kuba12 Mon, 2021-03-15 15:10 |
General discussion | ||
|
Trying to upgrade old Enertion FOCBOX Fw 2.18 by jyl087 on Fri, 2024-09-13 16:26 |
by jyl087 Fri, 2024-09-13 17:31 |
Third Party Hardware | ||
|
Problem after flash fw 3.38 detection faild dont spin by kataklysm_9090 on Tue, 2018-06-19 22:48 |
by kataklysm_9090 Tue, 2018-06-19 22:48 |
VESC Firmware | ||
|
Arduino- UART Library Question... by arranto12 on Sun, 2022-01-02 09:57 |
by arranto12 Sun, 2022-01-02 09:57 |
General discussion | ||
|
Controller (VESC 6 based) dont like small motor by matrixgti on Mon, 2024-01-29 21:27 |
by matrixgti Fri, 2024-02-23 15:37 |
General discussion | ||
|
PWM length not correctly measured by ufechner on Tue, 2018-06-05 11:45 |
by ufechner Tue, 2018-06-05 11:45 |
VESC Firmware | ||
|
Drive frequency and command rate question by jediengineer on Sun, 2023-03-19 19:07 |
by jediengineer Sun, 2023-03-19 19:08 |
General discussion | ||
|
How to set up RF receiver for PPM or UART input? by adamdorr on Tue, 2020-01-07 16:23 |
by adamdorr Tue, 2020-01-07 16:23 |
General discussion |
Pages
