You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
ADC throttle lock. by Billy_Wiz on Mon, 2022-10-31 00:57 |
1 |
by vadicus Mon, 2022-10-31 19:51 |
General discussion | |
|
Control via UART and connect to VESC Tool using BLE by Seudo on Sun, 2023-12-17 21:34 |
1 |
by vadicus Thu, 2024-01-11 23:00 |
General discussion | |
|
VESC Input Using Raspberry Pi and Wiimote by Schizug on Wed, 2019-03-27 04:28 |
3 |
by Nelf Sat, 2020-08-08 01:13 |
General discussion | |
|
E-scooter/bike throttle by Pelle van wijk on Sun, 2019-12-01 17:03 |
7 |
by hummina Wed, 2020-10-14 05:02 |
General discussion | |
|
Differential steering setup by GCTech on Sat, 2020-07-04 17:38 |
4 |
by CalLangford Fri, 2024-09-20 20:29 |
General discussion | |
|
as5047d drift?,Vd voltage -10 by ziumus on Sat, 2021-02-20 20:38 |
3 |
by ziumus Tue, 2021-02-23 22:08 |
General discussion | |
|
noisy braking on vesc4 by lurch on Sat, 2021-10-30 10:30 |
by lurch Sat, 2021-10-30 10:48 |
General discussion | ||
|
starting current/torque with speed controller by nomada on Thu, 2023-11-30 12:20 |
by nomada Thu, 2023-11-30 12:20 |
General discussion | ||
|
Stop motor after certain number of rounds by Gawarmel on Wed, 2025-02-19 12:51 |
by Gawarmel Wed, 2025-02-19 12:51 |
General discussion | ||
|
Type of motors supported by VESC 6 MKIV by Sami Sahli on Thu, 2020-06-25 11:57 |
2 |
by Samuelx Tue, 2021-08-17 20:24 |
General discussion | |
|
Vesc tool not working by faheemift on Sun, 2021-02-14 14:44 |
4 |
by faheemift Wed, 2021-04-14 22:59 |
General discussion | |
|
Controling two motors with Dual FSESC6.6 in two directions by Rafal on Sat, 2021-10-16 13:47 |
1 |
by frank Mon, 2021-10-18 14:43 |
General discussion | |
|
Two Motors on same Shaft by Giga93 on Thu, 2017-12-14 10:12 |
5 |
by ThierryGTLTS Sun, 2017-12-17 13:20 |
General discussion | |
|
position control with gearbox by raess on Tue, 2018-09-25 23:48 |
19 |
by Artabotak Tue, 2024-12-03 08:48 |
General discussion | |
|
Drive frequency and command rate question by jediengineer on Sun, 2023-03-19 19:07 |
by jediengineer Sun, 2023-03-19 19:08 |
General discussion | ||
|
UAVCAN vs DroneCAN vs Cypal by AndreasSkaar on Fri, 2024-05-03 22:17 |
4 |
by Williamzoe2002 Thu, 2025-03-20 10:23 |
General discussion | |
|
Set McConf with no values --> bootloader erased? by Kakskiv on Tue, 2017-11-28 12:52 |
3 |
by basti30 Wed, 2018-08-22 22:22 |
General discussion | |
|
FAULT_CODE_DRV Motor not spinning by Mightyorc on Sat, 2018-09-15 03:36 |
by Mightyorc Sat, 2018-09-15 03:36 |
General discussion | ||
|
No Option for Master or Slave on SetUp Input? by trickleung91 on Sun, 2019-06-30 09:06 |
1 |
by frank Sun, 2019-07-21 18:46 |
General discussion | |
|
Big Inrunner - Noisy In FOC Mode by skeaux on Mon, 2020-03-02 04:13 |
2 |
by skeaux Tue, 2020-03-03 05:30 |
General discussion |
Pages
