You are here
Active forum topics
Primary tabs
Topic |
Replies | Last post | Forum | |
|---|---|---|---|---|
|
3.3V/5V External Electronics Raspberry Pi by ed muthiah on Sun, 2020-07-19 16:38 |
1 |
by TheFallen Mon, 2020-07-20 15:15 |
General discussion | |
|
3.3v short. is repair possible? by TZTZ on Sat, 2021-08-21 10:33 |
4 |
by tecnico.solarboat Mon, 2021-12-27 23:31 |
VESC Original Hardware | |
|
3 speed switch by de-bodgery on Sat, 2021-08-21 02:22 |
17 |
by Oscar Lozano Gimenez Mon, 2023-05-22 14:07 |
General discussion | |
|
3 shunt low side vs 3 shunt 'in phase' current sensing by ripperpc on Mon, 2020-05-04 08:47 |
6 |
by bww129 Wed, 2020-05-27 17:59 |
General discussion | |
|
3 shunt low side resistor configuration based on VESC 6 by jordanlow on Thu, 2019-02-14 16:42 |
1 |
by TechAUmNu Thu, 2019-02-14 18:31 |
Third Party Hardware | |
|
3 sensorless motors connected with belt by moose09876 on Wed, 2022-09-14 23:26 |
5 |
by moose09876 Fri, 2022-09-16 14:09 |
General discussion | |
|
3 Phase DC Motor and VESC by Mustard on Sun, 2021-05-23 19:03 |
1 |
by skyline1970 Sat, 2021-09-18 11:50 |
General discussion | |
|
2xVESC6.0 with identical T-Motor different start up result by tobiokanobi on Fri, 2024-10-04 15:26 |
3 |
by tobiokanobi Fri, 2024-10-04 23:07 |
VESC Original Hardware | |
|
2TWOW - Dual VESC for overhauling E-twow scooters (48V, 1kW peak per motor) by badgerthing on Sat, 2024-04-13 09:48 |
by badgerthing Sat, 2024-04-13 10:01 |
Third Party Hardware | ||
|
2nd Maytech 75_300 burned by Flyingtux on Wed, 2022-03-16 22:15 |
1 |
by skyline1970 Fri, 2022-03-25 19:00 |
General discussion | |
|
2kW motor with VESS 75200 by Sazabi on Fri, 2024-04-05 11:17 |
by Sazabi Fri, 2024-04-05 11:18 |
General discussion | ||
|
24v Kobalt Powered Sunjoe Mower by mistersketchman on Sun, 2020-08-02 01:54 |
by mistersketchman Sun, 2020-08-02 01:55 |
Third Party Hardware | ||
|
24 Volt LiFePO by Vaxinius on Tue, 2024-09-10 16:34 |
by Vaxinius Tue, 2024-09-10 16:35 |
General discussion | ||
|
22 pole motor and potentiometer throttle by Kenneth on Mon, 2020-04-27 23:01 |
1 |
by Kenneth Tue, 2020-04-28 08:59 |
General discussion | |
|
20x4.0 fat bike with Bafang geared hub motor (low torque) by Ro on Tue, 2024-04-16 10:30 |
1 |
by Buddy Love Sat, 2024-08-10 19:07 |
General discussion | |
|
20S by ahanktcd on Thu, 2024-04-25 14:51 |
by ahanktcd Thu, 2024-04-25 14:51 |
General discussion | ||
|
200V +200A power stage and custom VESC controller with fault protection by ZombieSS on Sat, 2020-07-18 07:35 |
3 |
by mystamo Tue, 2020-07-28 22:07 |
Third Party Hardware | |
|
200kHz PWM by c10yas on Sun, 2019-09-22 17:06 |
2 |
by Eric Thu, 2019-11-07 18:09 |
VESC Firmware | |
|
2 vs 3 phase shunts by antonchromjak on Sun, 2018-04-15 13:25 |
13 |
by TechAUmNu Fri, 2019-02-15 18:57 |
General discussion | |
|
2 VESC 100/200 single power on switch by tobiokanobi on Wed, 2022-08-31 16:06 |
4 |
by tobiokanobi Mon, 2022-09-05 11:44 |
VESC Original Hardware |
Pages
