You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
5.02 Firmware on Trampa VESC 6 MKVI? by maxhertz on Sun, 2023-01-15 13:58 |
2 |
by maxhertz Mon, 2023-01-16 00:24 |
General discussion | |
|
VESC hybrid drone generator by sander123 on Thu, 2024-03-07 10:55 |
1 |
by electricfox Sat, 2024-03-09 19:02 |
General discussion | |
|
Alternator custom VESC hardware: Looking for collaborators by jon@ifold on Wed, 2020-01-15 20:11 |
1 |
by frank Thu, 2020-01-16 16:32 |
General discussion | |
|
Control a 3 phase linear induction motor with vesc by Choocie on Wed, 2020-08-05 14:19 |
1 |
by TheFallen Thu, 2020-08-06 23:56 |
General discussion | |
|
Motor seize and ERPM current ramp speed by krabsheva on Tue, 2025-05-13 06:49 |
by krabsheva Tue, 2025-05-13 07:00 |
General discussion | ||
|
VESC Tool FOC detect success, but no motor running by w0nseok on Sun, 2021-11-28 11:09 |
1 |
by frank Sun, 2021-11-28 20:03 |
General discussion | |
|
VESC Not Functioning with Magnetic or Quadrature Encoders by privvyledge on Wed, 2023-05-24 16:59 |
1 |
by electricfox Thu, 2023-05-25 21:10 |
General discussion | |
|
Fried C51(?) on my VESC 4.12 by spork on Tue, 2018-11-27 07:00 |
6 |
by spork Thu, 2018-11-29 16:43 |
General discussion | |
|
Vesc to Uart (Nextion display) by g1tana on Mon, 2019-08-19 15:29 |
by g1tana Mon, 2019-08-19 15:30 |
General discussion | ||
|
Welding with the VESC by doomy1986 on Mon, 2020-04-13 14:38 |
by doomy1986 Mon, 2020-04-13 14:38 |
General discussion | ||
|
resistance and inductance value changes when each measurement by alexshen2012 on Fri, 2022-07-01 05:42 |
by alexshen2012 Fri, 2022-07-01 05:42 |
General discussion | ||
|
Motor is "pumping" under load in current control mode. is this normal? by etienne on Sat, 2023-05-13 17:16 |
2 |
by iv.kravchenko Sat, 2023-05-20 08:31 |
General discussion | |
|
VESC Firm for Xiaomi ESC (STM32F103) uC by Foujiwara on Sat, 2020-04-04 19:16 |
3 |
by cara Mon, 2023-08-28 04:45 |
General discussion | |
|
help needed with raptor 2 remote by dave9401 on Mon, 2020-11-02 10:26 |
by dave9401 Mon, 2020-11-02 10:26 |
General discussion | ||
|
Emergency Stop SSR - Blowing up Microcontroller by J_W97 on Tue, 2022-03-01 14:46 |
5 |
by frank Tue, 2022-03-01 20:19 |
General discussion | |
|
Using an on/off throttle by Evwan on Mon, 2021-05-24 16:59 |
1 |
by SamuL Wed, 2021-05-26 12:52 |
General discussion | |
|
Vesc gps control by Erik on Thu, 2019-11-14 20:38 |
by Erik Thu, 2019-11-14 20:38 |
General discussion | ||
|
Custom-made VESC PCB: High current sensor offset/Overcurrent fault during motor detection, possible hardware/firmware mismatch by Chinmay Mulgund on Mon, 2025-10-13 13:56 |
by Chinmay Mulgund Mon, 2025-10-13 14:02 |
General discussion | ||
|
Trying to run a refrigerant compressor's BLDC with VESC by logansheaf on Wed, 2025-01-29 02:01 |
2 |
by logansheaf Wed, 2025-01-29 23:23 |
General discussion | |
|
VESC 6 motor setup: Resistance measurement jumps by thomasjfox on Mon, 2017-10-09 20:42 |
2 |
by thomasjfox Sat, 2017-10-28 21:57 |
General discussion |
Pages
