You are here
Active forum topics
Primary tabs
Topic |
Replies![]() |
Last post | Forum | |
---|---|---|---|---|
Motors with known valid configurations by doctarr on Fri, 2021-01-01 14:28 |
4 |
by doctarr Sat, 2021-01-09 14:44 |
Third Party Hardware | |
Bafang hub motor setup by Kent Tabor on Fri, 2020-10-16 03:48 |
4 |
by Racing2Learn Sun, 2024-05-05 18:31 |
VESC Tool | |
Full Throttle direct after input deadband by toerde on Sat, 2022-04-30 18:54 |
4 |
by frank Mon, 2022-05-09 08:22 |
General discussion | |
ADC1 problems with Firmware/Hardware issue? by sam.vanratt on Thu, 2018-12-27 22:31 |
4 |
by sam.vanratt Thu, 2019-01-03 17:46 |
General discussion | |
CanOpen by maxmertins on Mon, 2023-01-30 17:10 |
4 |
by maxmertins Wed, 2023-02-01 17:24 |
General discussion | |
controlling 2 motors for two directions each by ori harush on Mon, 2022-06-06 07:17 |
4 |
by Indy8976 Tue, 2022-06-21 13:36 |
General discussion | |
No reverse after FW update from 3.62 to 3.63 by Stupidspencer on Sun, 2019-12-15 20:34 |
4 |
by Stupidspencer Sun, 2019-12-22 21:57 |
VESC Firmware | |
how to download v5.03 firmware? by barncat08 on Wed, 2022-01-26 18:35 |
4 |
by Gatze Sat, 2022-04-23 11:48 |
VESC Firmware | |
PPM: Full Duty-Cycle at approx. 15% Throttle by el micha on Thu, 2017-08-10 11:11 |
4 |
by frank Wed, 2021-07-28 12:10 |
VESC6 Beta | |
VESC75/300 - Does your IMU work? by Gerhard on Mon, 2021-02-08 00:15 |
4 |
by Gerhard Thu, 2021-02-25 17:39 |
VESC Original Hardware | |
Get Current over CAN bus by chriswei on Thu, 2019-05-16 13:57 |
4 |
by spacewalker Mon, 2022-02-21 08:25 |
VESC Firmware | |
Increasing phase amps beyond 300a on 100-250 by reubarb.scons on Tue, 2022-03-15 07:30 |
4 |
by reubarb.scons Thu, 2022-03-17 22:28 |
VESC Original Hardware | |
VESC hardware schematics by cromoly on Tue, 2017-11-28 04:44 |
4 |
by ThierryGTLTS Tue, 2017-12-19 14:03 |
VESC Original Hardware | |
lispBM on VESC for special algorithm by Fusion on Fri, 2024-10-25 11:34 |
4 |
by Fusion Sat, 2024-10-26 17:00 |
General discussion | |
E-Bike Throttle connect with Regenerative Braking by E-Toxx on Sat, 2017-09-09 09:38 |
4 |
by Jacki Villis Thu, 2019-05-16 14:43 |
General discussion | |
Negative current on full duty by zhivko on Mon, 2024-06-24 23:51 |
4 |
by electricfox Thu, 2024-06-27 10:38 |
VESC Firmware | |
3.3v short. is repair possible? by TZTZ on Sat, 2021-08-21 10:33 |
4 |
by tecnico.solarboat Mon, 2021-12-27 23:31 |
VESC Original Hardware | |
Customization of Firmware by EnricoB on Mon, 2018-11-19 23:01 |
4 |
by EnricoB Sun, 2018-11-25 21:03 |
VESC Firmware | |
VESC 75/300 + ~20kW motor , bms configuration problem... by gucho on Sat, 2019-10-26 14:45 |
4 |
by hockinsk Mon, 2019-10-28 21:33 |
General discussion | |
VESC Tool disappeared from App Store by volkswagenbug on Thu, 2024-06-13 21:40 |
4 |
by Sybernetix Sat, 2024-06-15 11:32 |
VESC Tool |
Pages
