You are here
Active forum topics
Primary tabs
Topic |
Replies | Last post | Forum | |
|---|---|---|---|---|
|
(Watchdog) - Resets with multipole engine. by edilger on Mon, 2023-06-26 12:33 |
by edilger Mon, 2023-06-26 12:33 |
VESC Firmware | ||
|
(SOLVED) I2C, change pins by CTSchorsch on Mon, 2020-05-25 07:59 |
6 |
by woodmastr Tue, 2023-06-06 15:57 |
VESC Firmware | |
|
(solved) Configuration smooth motordirection change by horak2084 on Mon, 2019-02-25 20:44 |
9 |
by fpagac Sat, 2020-04-25 17:17 |
VESC Firmware | |
|
(Open source) BMS by soltesz on Mon, 2017-12-18 00:26 |
2 |
by Pimousse Mon, 2018-01-08 16:26 |
Third Party Hardware | |
|
(Not) Stator saturation by Stupidspencer on Sun, 2019-10-13 00:34 |
5 |
by rfedyukovich Sun, 2024-06-16 20:16 |
General discussion | |
|
(CLOSED)Custom FW based on beta "could not deserialize" by pe on Wed, 2021-12-15 11:48 |
by pe Wed, 2021-12-15 15:18 |
VESC Development and Beta Testing | ||
|
"Throttle" help by benha on Wed, 2019-08-07 05:58 |
by benha Wed, 2019-08-07 05:58 |
General discussion | ||
|
"Porting" VESC FW to physically smaller device? by Jackl on Fri, 2020-03-13 14:04 |
2 |
by Jackl Mon, 2020-03-16 14:52 |
VESC Firmware | |
|
"Could not read Firmware version" when connecting via Bluetooth by ligi on Tue, 2020-11-17 07:03 |
14 |
by Gmcruz463 Fri, 2025-01-17 18:28 |
General discussion | |
|
"CAN bus support is not enabled in this build of VESC Tool" by hdfghdfgh on Wed, 2023-04-26 16:13 |
5 |
by Nshoup Sat, 2026-01-10 01:30 |
VESC Tool | |
|
"bad detection result received" impossible to achieved motor detection ! by titimomotete on Wed, 2019-03-20 17:21 |
2 |
by doom Mon, 2019-08-05 10:52 |
VESC Tool | |
|
"Allow Breaking" set to "TRUE" when "Backup COnfigurations (Including CAN) by bayetan on Mon, 2023-05-22 05:33 |
by bayetan Mon, 2023-05-22 05:33 |
VESC Tool | ||
|
Voltage Calibration by Frantin on Mon, 2026-04-20 21:40 |
by Frantin Mon, 2026-04-20 21:40 |
General discussion | ||
|
Vesc tool app x Spinted Ubox by Thomas Leduc on Fri, 2021-07-16 10:10 |
by Thomas Leduc Mon, 2021-08-16 08:50 |
Third Party Hardware | ||
|
VESC & Raspberry & Jetson by Andrea on Tue, 2020-05-19 15:58 |
1 |
by SimpleUnmanned Thu, 2020-05-21 02:44 |
General discussion | |
|
How to activate e-brake on e-scooter with the throttle by Donatas Sukelis on Sat, 2019-04-27 10:09 |
by Donatas Sukelis Sat, 2019-04-27 10:09 |
VESC Tool | ||
|
How deactivate Cruise Control vithout button? It is posible deactivate with 2 pin brake sensor or brake throttle? by denon480 on Fri, 2025-08-22 18:22 |
by denon480 Fri, 2025-08-22 18:25 |
General discussion | ||
|
Flipsky Dual 75100 forward, brake, and reverse by Shockwave333 on Wed, 2023-02-15 02:58 |
1 |
by voodoobrew Sat, 2025-12-20 23:40 |
Third Party Hardware | |
|
Flipsky and Trampa getting two very different detected resistances on same motor! by colmor on Wed, 2025-05-28 22:52 |
by colmor Wed, 2025-05-28 22:52 |
General discussion | ||
|
dual vesc by badger1666 on Fri, 2018-09-21 09:10 |
4 |
by badger1666 Sat, 2018-09-29 15:45 |
General discussion |
Pages
