You are here
Active forum topics
Primary tabs
Topic |
Replies | Last post | Forum | |
|---|---|---|---|---|
|
5phase Vesc based on 75/300 by BartE on Thu, 2020-03-05 23:17 |
8 |
by vadicus Sun, 2020-03-08 05:51 |
General discussion | |
|
5000 rpm BLDC, 1600 rpm FOC by scubersteve on Mon, 2022-03-21 03:10 |
1 |
by skyline1970 Fri, 2022-03-25 18:45 |
VESC Tool | |
|
5.02 Firmware on Trampa VESC 6 MKVI? by maxhertz on Sun, 2023-01-15 13:58 |
2 |
by maxhertz Mon, 2023-01-16 00:24 |
General discussion | |
|
4wd rover using hub-motors by mhyer on Thu, 2023-05-18 09:56 |
2 |
by velolac Tue, 2023-05-23 10:03 |
General discussion | |
|
4kw BLDC hybrid system help by thardi10 on Tue, 2019-01-08 17:06 |
2 |
by frank Tue, 2019-01-15 22:15 |
General discussion | |
|
4k monitor problem by nlabs on Wed, 2017-11-01 07:36 |
3 |
by benjamin Fri, 2017-11-03 09:22 |
VESC Tool | |
|
48v problems by vufmihai on Wed, 2020-07-22 22:53 |
2 |
by vufmihai Fri, 2020-07-31 07:25 |
VESC Tool | |
|
48V Battery cuts off while doing Motor Wizard by NiZZioN on Sun, 2022-04-24 15:31 |
1 |
by kexbox Fri, 2022-05-06 16:32 |
Third Party Hardware | |
|
48N32P sync loss by roque.canales on Fri, 2023-08-18 11:01 |
by roque.canales Fri, 2023-08-18 11:01 |
General discussion | ||
|
4.2 hw Erpm bldc mode by Katt on Wed, 2021-01-27 15:48 |
2 |
by Katt Tue, 2021-02-02 14:16 |
General discussion | |
|
4.12 Phase current/voltage sense mix up. Need assistance please. by shaman on Tue, 2019-01-29 14:58 |
2 |
by shaman Tue, 2019-01-29 16:24 |
Third Party Hardware | |
|
4.12 HK VESC - Static blue LED and no usb Connection, HELP!! by plot1992 on Thu, 2018-08-02 19:01 |
5 |
by Frazatto Tue, 2018-08-28 15:43 |
General discussion | |
|
4.12 Hardware without drv chip by Gatze on Thu, 2021-08-26 11:13 |
1 |
by skyline1970 Sat, 2021-09-18 11:32 |
Third Party Hardware | |
|
4.12 cooling mod by thewho on Wed, 2019-05-01 18:45 |
by thewho Wed, 2019-05-01 18:45 |
General discussion | ||
|
4 vesc motors at once? by i-make-robots on Thu, 2020-04-16 02:17 |
1 |
by hexakopter Sat, 2020-04-18 12:20 |
General discussion | |
|
4 fried vesc's Australia by adamclarke1985 on Tue, 2020-03-31 20:48 |
by adamclarke1985 Tue, 2020-03-31 21:24 |
General discussion | ||
|
4 BLDC for 1 VESC by mac_cros on Wed, 2019-03-20 16:45 |
8 |
by tul00985 Wed, 2019-04-03 08:32 |
Third Party Hardware | |
|
3v3 Regulator fried? How to check if STM was affected too? by Seudo on Fri, 2024-02-16 19:48 |
1 |
by bww129 Fri, 2024-03-15 05:36 |
General discussion | |
|
3Shul controller gokart by th3v3rn on Thu, 2024-01-18 07:14 |
by th3v3rn Thu, 2024-01-18 07:17 |
General discussion | ||
|
3Shul 700A reporting negative current spikes by reobaird on Sat, 2023-03-25 03:22 |
by reobaird Mon, 2023-03-27 09:34 |
General discussion |
Pages
