You are here
Active forum topics
Primary tabs
Topic |
Replies | Last post | Forum | |
|---|---|---|---|---|
|
current proportional pwm signal by grkn5434 on Mon, 2020-02-24 11:42 |
2 |
by grkn5434 Mon, 2020-02-24 15:40 |
General discussion | |
|
Current out of Sync by CTSchorsch on Sat, 2020-08-01 13:24 |
18 |
by CTSchorsch Fri, 2020-09-04 11:28 |
Third Party Hardware | |
|
current of holding by reff on Thu, 2022-01-27 16:38 |
by reff Thu, 2022-01-27 16:39 |
VESC Tool | ||
|
Current mismatch between power supply and vesc tool by mansi712 on Tue, 2024-09-24 13:02 |
by mansi712 Tue, 2024-09-24 18:08 |
General discussion | ||
|
Current measuring with DRV amplifiers by PXSS on Mon, 2018-02-12 03:14 |
5 |
by lizardmech Fri, 2018-03-02 00:43 |
VESC Original Hardware | |
|
current measurements crazy high after replacing DRV8301 with DRV8302, it throws a FAULT_CODE_ABS_OVER_CURRENT by idkanythinggoes on Thu, 2021-03-18 04:34 |
by idkanythinggoes Thu, 2021-03-18 04:34 |
General discussion | ||
|
Current measurement VESC Tool 1.16 by mdbb on Thu, 2020-03-19 17:16 |
by mdbb Thu, 2020-03-19 17:16 |
VESC Tool | ||
|
Current measurement by Toto on Sun, 2021-02-07 09:12 |
1 |
by skyline1970 Tue, 2021-02-09 19:40 |
General discussion | |
|
Current loop resonance in higher ERPM under Current Mode by ypl on Sat, 2019-07-20 09:34 |
by ypl Sat, 2019-07-20 09:34 |
General discussion | ||
|
Current limit problem by albheim on Fri, 2022-09-09 10:34 |
2 |
by albheim Fri, 2022-09-09 13:24 |
General discussion | |
|
Current KP(Current controller proportional gain) by Geir Henriksen on Tue, 2019-04-30 10:51 |
1 |
by Ricardo Bosqui Tue, 2020-02-11 15:12 |
General discussion | |
|
Current In vs Current Motor by hacksmithCabe on Thu, 2021-09-30 21:59 |
5 |
by y-hasebe Mon, 2021-12-13 15:17 |
VESC Tool | |
|
Current filters on VESC MKIII? by Elwin on Sat, 2021-11-06 11:16 |
7 |
by vadicus Thu, 2022-05-05 01:26 |
General discussion | |
|
Current controller issue - Glitches at low current, low RPM by GijsB on Sun, 2022-10-30 12:59 |
1 |
by GijsB Sun, 2022-10-30 15:37 |
General discussion | |
|
current control via CAN not working by STTS on Thu, 2021-08-12 11:51 |
2 |
by mm_iem Mon, 2021-08-30 18:00 |
VESC Tool | |
|
Current control performance & best way to tune Kp and Ki by jinwonchung on Thu, 2024-10-17 15:52 |
by jinwonchung Thu, 2024-10-17 15:53 |
General discussion | ||
|
current control mode with duty cycle limit based on throttle by devin on Thu, 2020-01-16 05:45 |
by devin Thu, 2020-01-16 05:49 |
General discussion | ||
|
Current Control issue VESC4 by yosoufe on Tue, 2018-03-20 09:28 |
5 |
by itchavenag Fri, 2019-09-13 12:06 |
General discussion | |
|
Current control and duty cycle issues. by ESCam on Tue, 2019-04-02 22:55 |
by ESCam Tue, 2019-04-02 22:55 |
General discussion | ||
|
Current calculation in BLDC Mode with 3 shunts fails in v6.05 by STMBLUE on Wed, 2023-08-30 19:48 |
1 |
by STMBLUE Thu, 2023-08-31 14:46 |
VESC Development and Beta Testing |
Pages
