You are here
Active forum topics
Primary tabs
Topic |
Replies | Last post | Forum | |
|---|---|---|---|---|
|
Sudden drop in speed after releasing throttle in FW mode by shokrabi on Sat, 2022-04-23 15:05 |
4 |
by DeuceDos Tue, 2023-05-30 09:54 |
General discussion | |
|
Sudden hard acceleration at around 30 km/h. Help by kristofferbenjaminw on Tue, 2022-10-04 17:31 |
4 |
by Chris Barth Tue, 2022-10-11 20:05 |
General discussion | |
|
Sudden kick (from motor current cut off?) by darowi on Mon, 2017-10-02 18:56 |
5 |
by darowi Tue, 2020-09-15 12:45 |
General discussion | |
|
Sudden motor stop by dmcke5 on Wed, 2018-08-15 13:50 |
2 |
by andreas Thu, 2018-09-06 20:48 |
General discussion | |
|
Sudden vesc unresponsiveness by nolander on Mon, 2019-01-07 22:29 |
6 |
by Caustic_Zinc Mon, 2019-02-11 09:32 |
VESC Tool | |
|
Suddenly broken by moto_guy on Fri, 2019-03-08 13:50 |
10 |
by David_1 Fri, 2022-06-17 21:07 |
General discussion | |
|
Suggestion for new forum area by Snabelost on Thu, 2022-10-06 23:55 |
2 |
by Snabelost Tue, 2022-10-11 18:30 |
General discussion | |
|
Summerboard VESC Problems by teijidude on Sat, 2020-09-12 22:19 |
by teijidude Sat, 2020-09-12 22:19 |
Third Party Hardware | ||
|
Support for AMC1301 powered from bootstrap by antonchromjak on Thu, 2019-04-04 22:46 |
2 |
by antonchromjak Fri, 2019-04-05 11:16 |
Feature Requests | |
|
supported firmware by velolac on Mon, 2020-01-13 22:55 |
3 |
by velolac Tue, 2020-01-14 21:47 |
VESC Tool | |
|
swagatron hoverboard motors with VESC by popeye243 on Tue, 2020-07-21 02:49 |
13 |
by popeye243 Mon, 2020-09-07 03:42 |
General discussion | |
|
swap PWM H and PWM L Pins on STM32F4 by Urs_Harry on Tue, 2022-03-15 23:04 |
3 |
by skyline1970 Thu, 2022-03-17 09:58 |
General discussion | |
|
Switch between different modes via remote by Cledus on Sun, 2017-10-22 13:56 |
2 |
by MatwoSvK Tue, 2017-11-07 22:32 |
VESC Tool | |
|
Switch between pre-defined profiles over UART by PutridFox on Sun, 2025-06-15 13:11 |
by PutridFox Sun, 2025-06-15 13:11 |
General discussion | ||
|
Switch two Motor Profiles/Modes (UART) by anli on Thu, 2018-08-16 19:02 |
7 |
by basti30 Sun, 2018-09-30 19:55 |
General discussion | |
|
switch/toggle between two different engine settings/characteristics by Lasse on Tue, 2020-12-29 23:18 |
1 |
by skyline1970 Sun, 2021-02-07 17:35 |
VESC Original Hardware | |
|
Switchign frequency issue? by Maxid on Thu, 2020-12-03 11:47 |
by Maxid Thu, 2020-12-03 11:47 |
VESC Firmware | ||
|
Switching between hall and observer by eptv on Thu, 2019-12-05 08:49 |
1 |
by frank Thu, 2019-12-05 10:54 |
General discussion | |
|
Switching control scheme during opertion by Ben Murton on Tue, 2023-01-31 02:57 |
1 |
by Gos1 Mon, 2023-06-26 12:07 |
General discussion | |
|
Switching Frequency and current loop speed by bobfrank on Tue, 2019-04-23 10:34 |
2 |
by jerome Wed, 2019-05-08 18:48 |
VESC Firmware |
Pages
