You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
Incorrect Batt Current Readings in FOC but not in BLDC by vadicus on Tue, 2020-02-25 20:06 |
by vadicus Tue, 2020-02-25 20:09 |
General discussion | ||
|
Custom-made VESC PCB: High current sensor offset/Overcurrent fault during motor detection, possible hardware/firmware mismatch by Chinmay Mulgund on Mon, 2025-10-13 13:56 |
by Chinmay Mulgund Mon, 2025-10-13 14:02 |
General discussion | ||
|
eRPM limited to 40600 or so on 6.6 by Dan Slanker on Fri, 2021-04-16 01:22 |
6 |
by electricfox Wed, 2025-06-18 10:11 |
General discussion | |
|
Current limit problem by albheim on Fri, 2022-09-09 10:34 |
2 |
by albheim Fri, 2022-09-09 13:24 |
General discussion | |
|
Change RPM of motor by Gas_Sn4ke on Wed, 2019-01-16 03:51 |
2 |
by Shaik Siraaj Thu, 2019-01-17 11:14 |
General discussion | |
|
Forward/brake/reverse mode? by RDN2003 on Thu, 2019-10-03 02:13 |
9 |
by Toymanfrank Sun, 2026-04-26 03:49 |
General discussion | |
|
Did I damage My Vesc? by Kent Church on Tue, 2022-01-11 04:47 |
1 |
by skyline1970 Wed, 2022-01-19 09:46 |
General discussion | |
|
Are all VESC based ESCs within the same generation standardized in their sensors and data payloads? by pearlgreymusic on Sat, 2022-08-27 11:43 |
2 |
by pearlgreymusic Tue, 2022-09-06 14:24 |
General discussion | |
|
Multiple VESC not working with PAS app? by radverkehr-labo... on Wed, 2024-10-16 12:57 |
1 |
by radverkehr-labo... Wed, 2024-10-16 13:36 |
General discussion | |
|
Wand remote with non-Trampa boards by hans_maier on Fri, 2019-09-20 23:18 |
1 |
by frank Sat, 2019-09-28 21:46 |
General discussion | |
|
Wheel speed over CANBUS by paule on Tue, 2020-12-29 13:04 |
by paule Tue, 2020-12-29 13:04 |
General discussion | ||
|
Using UART for FSESC by Kostya1875 on Thu, 2024-09-26 19:07 |
1 |
by Nineballshot Mon, 2024-11-25 02:04 |
General discussion | |
|
Newby RPM question by dirkske on Mon, 2018-06-18 23:00 |
7 |
by dirkske Wed, 2018-06-20 20:45 |
General discussion | |
|
Double the Input voltage, now more rpm at load by martin2day on Tue, 2021-07-20 20:26 |
2 |
by martin2day Sat, 2021-07-31 13:47 |
General discussion | |
|
Problem with regenerative breaking by ligi on Sat, 2022-04-02 15:08 |
4 |
by ligi Sat, 2023-07-15 02:02 |
General discussion | |
|
overload cut off by TONY61 on Mon, 2026-08-10 10:04 |
by TONY61 Mon, 2026-08-10 10:04 |
General discussion | ||
|
Voltage vs Heating ? by marko on Thu, 2019-04-25 21:40 |
1 |
by moto_guy Fri, 2019-04-26 06:02 |
General discussion | |
|
Up dating firmware by rossco1959 on Mon, 2020-01-06 03:44 |
3 |
by rossco1959 Wed, 2020-01-08 02:06 |
General discussion | |
|
Balancing Throttle by kstuck on Mon, 2022-12-12 22:31 |
1 |
by frank Tue, 2022-12-13 10:37 |
General discussion | |
|
FSESC 75100 motor problem by anythingstl on Tue, 2024-02-13 17:15 |
by anythingstl Mon, 2024-02-19 19:23 |
General discussion |
Pages
