You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
Which encoders are supported? by raess on Thu, 2018-03-22 23:38 |
2 |
by raess Fri, 2018-03-23 22:58 |
General discussion | |
|
Can't Update Firmware by indianboy42 on Mon, 2024-06-17 08:54 |
by indianboy42 Mon, 2024-06-17 08:54 |
General discussion | ||
|
PID gains by spacemango on Mon, 2020-06-08 21:16 |
1 |
by spacemango Tue, 2020-06-09 16:53 |
General discussion | |
|
[SOLVED, was a mistake] Set ERPM command: issue with the speed controller with higher speed values that is possible with bat vol by yes_wecangogreen on Wed, 2023-04-12 00:51 |
1 |
by yes_wecangogreen Sat, 2023-04-29 09:24 |
General discussion | |
|
High res ABI encoder on Vesc not working by JH on Sun, 2026-01-25 01:23 |
by JH Sun, 2026-01-25 01:23 |
General discussion | ||
|
vesc for autonomous robots by _saeed_arabi_ on Tue, 2019-10-15 00:25 |
2 |
by Mayank Wed, 2023-06-07 00:05 |
General discussion | |
|
Do I need a motor with Hall sensor to use Vesc tool? by greew on Sun, 2020-05-31 06:48 |
by greew Sun, 2020-05-31 06:48 |
General discussion | ||
|
BIG Flash/Spark!!!!! New 100v/250a :-( by Fpvlee on Thu, 2021-05-13 03:17 |
4 |
by Fpvlee Tue, 2021-05-25 00:12 |
General discussion | |
|
Problems with UART communication via Arduino UNO by Michael Hamm on Fri, 2022-02-04 13:29 |
by Michael Hamm Fri, 2022-02-04 13:29 |
General discussion | ||
|
Running motors under 900ERPM in speed control by Chieflouis01 on Thu, 2025-11-27 21:32 |
2 |
by Chieflouis01 Thu, 2025-11-27 21:33 |
General discussion | |
|
Why not using interrupt for Hall signal detection? by kuan on Sun, 2021-01-03 09:51 |
by kuan Sun, 2021-01-03 09:51 |
General discussion | ||
|
Why i cant insert a topic? by SafrdA on Thu, 2021-04-29 20:41 |
by SafrdA Thu, 2021-04-29 20:41 |
General discussion | ||
|
SPINTEND UBOX 100v100a x2 or Flipsky 75100 100v100a x2 by DuckyTheDuck on Mon, 2022-09-26 12:07 |
4 |
by primarc1982 Sat, 2026-05-09 07:16 |
General discussion | |
|
Programming NRF51822 Module with ST-Link v2 by koralle on Wed, 2018-07-11 12:06 |
3 |
by koralle Sun, 2018-07-15 01:28 |
General discussion | |
|
DC-Link Capacitor Selection by rushi95 on Sat, 2019-05-18 12:15 |
1 |
by hexakopter Sat, 2019-05-18 12:39 |
General discussion | |
|
Help with FOC/PID parameter by CTSchorsch on Thu, 2020-01-23 21:57 |
by CTSchorsch Thu, 2020-01-23 21:57 |
General discussion | ||
|
Controlling general BLDC motors by sinned6915 on Wed, 2020-08-19 01:56 |
3 |
by thefallen Sun, 2020-08-23 16:51 |
General discussion | |
|
HFI optimisation with increase in switching frequency by rainebk@bigpond... on Tue, 2022-09-13 06:53 |
by rainebk@bigpond... Tue, 2022-09-13 06:53 |
General discussion | ||
|
VESC 6.05/STR500 ADC1 dead by amblerev on Mon, 2024-11-18 20:02 |
1 |
by electricfox Mon, 2024-11-18 21:06 |
General discussion | |
|
step/dir by blueflower on Thu, 2020-01-16 04:15 |
5 |
by akkoxe Mon, 2022-08-08 06:34 |
General discussion |
Pages
