You are here
Active forum topics
Primary tabs
Topic | Replies | Last post | Forum | |
---|---|---|---|---|
Raptor 2 by Phill Dixon on Wed, 2018-06-13 18:07 |
1 |
by frank Fri, 2018-06-22 11:35 |
General discussion | |
Defining when Watt-hour / Amp-hour Data are rezeroed by isabar on Sun, 2018-06-24 10:19 |
by isabar Sun, 2018-06-24 10:19 |
Feature Requests | ||
Different HW versions for V6?! by Marc Pflugmann on Sun, 2018-06-24 13:43 |
1 |
by frank Mon, 2018-06-25 13:01 |
VESC Original Hardware | |
Vesc tool won't connect vesc to motor by moza1313 on Sat, 2018-06-16 10:25 |
2 |
by frank Tue, 2018-06-26 08:48 |
General discussion | |
Motor only running in reverse by obex_mike on Mon, 2018-06-25 16:25 |
2 |
by frank Tue, 2018-06-26 12:36 |
General discussion | |
Dead VESC6 due to shot from UBEC, repair possible? by Boesila on Sat, 2018-04-14 11:35 |
9 |
by benjamin Tue, 2018-06-26 14:37 |
VESC6 Beta | |
VESC with Raspberry Pi 3 by Antonio Rodrígu... on Sun, 2018-06-03 18:54 |
9 |
by ShortCircuit Thu, 2018-06-28 15:33 |
General discussion | |
Vesc Tool cannot detect firmware by MARK EVERITT on Sat, 2018-06-30 18:36 |
by MARK EVERITT Sat, 2018-06-30 18:36 |
VESC Firmware | ||
DC motor mode bricks firmware by TechAUmNu on Fri, 2018-05-04 12:58 |
1 |
by TechAUmNu Mon, 2018-07-02 11:20 |
VESC Firmware | |
can't communicate with arduino nrf by m.juan on Mon, 2018-07-02 16:57 |
by m.juan Mon, 2018-07-02 16:57 |
General discussion | ||
Help with Built-in NRF24 and custom remote by solidgeek on Thu, 2017-06-15 00:35 |
15 |
by m.juan Mon, 2018-07-02 18:06 |
VESC6 Beta | |
servo input by Roger Wolff on Tue, 2018-07-03 07:50 |
by Roger Wolff Tue, 2018-07-03 07:50 |
VESC Firmware | ||
VESC Control over NRF by Christian on Tue, 2018-03-27 14:42 |
1 |
by m.juan Wed, 2018-07-04 13:44 |
VESC Firmware | |
Cruise control by setting RPM over UART by solidgeek on Thu, 2018-02-15 10:56 |
3 |
by Lzx19961014 Thu, 2018-07-05 11:20 |
General discussion | |
Overheat by Phill Dixon on Tue, 2018-07-03 19:07 |
1 |
by frank Tue, 2018-07-10 09:51 |
General discussion | |
FW Vesc-Tool V0.95 by Meche on Mon, 2018-07-09 21:07 |
1 |
by Meche Wed, 2018-07-11 16:29 |
General discussion | |
Updating fw by Phill Dixon on Fri, 2018-07-06 19:30 |
1 |
by frank Fri, 2018-07-13 13:19 |
General discussion | |
Bad detection problem by baron456 on Fri, 2018-06-29 17:56 |
5 |
by frank Fri, 2018-07-13 14:41 |
VESC Tool | |
Programming NRF51822 Module with ST-Link v2 by koralle on Wed, 2018-07-11 12:06 |
3 |
by koralle Sun, 2018-07-15 01:28 |
General discussion | |
Failure of FOC mode brake by jzy1115 on Sun, 2018-03-25 10:23 |
8 |
by iscle Sun, 2018-07-15 19:19 |
General discussion |