You are here

Third Party Hardware

Topic / Topic starter Repliessort descending Last post
Normal topic New need help
by VinnyF » Tue, 2019-12-10 13:16
2
by tex
Wed, 2019-12-11 17:19
Normal topic Vx1 controller help
by stefann » Wed, 2020-03-11 12:42
2
by stefann
Sun, 2020-03-15 00:36
Normal topic vesc 4.12 disaster
by stefann » Fri, 2020-05-08 18:54
2
by stefann
Thu, 2020-05-14 19:28
Normal topic SpaceVESC, a modular small VESC
by SpaceVESCproject » Wed, 2019-10-02 21:35
2
by frank
Thu, 2019-10-17 11:47
Normal topic Problems with Maytech MTVESC6.12
by TheJohnson » Mon, 2020-10-19 04:50
2
by TheJohnson
Wed, 2020-10-21 09:39
Normal topic Is my custom motor inductance too low?
by perpetum » Wed, 2020-11-04 18:01
2
by perpetum
Sat, 2020-11-28 18:28
Normal topic compatability assistance
by NRGFPV » Mon, 2020-12-28 04:58
2
by NRGFPV
Wed, 2020-12-30 08:46
Normal topic Flipsky Dual FSESC6.6 loses connection, connected BLDC buzzing after restart
by gabrielredding » Mon, 2019-04-29 00:00
2
by gabrielredding
Mon, 2019-04-29 00:37
Normal topic VESC 6 with 3 phase shunts to ground instead
by shaman » Wed, 2019-01-30 21:23
2
by shaman
Thu, 2019-01-31 15:33
Normal topic (Open source) BMS
by soltesz » Mon, 2017-12-18 00:26
2
by Pimousse
Mon, 2018-01-08 16:26
Normal topic Fault finding on failed VESC
by dmcke5 » Sun, 2019-02-17 01:57
2
by benjamin
Wed, 2019-03-13 10:00
Normal topic Custom PCB based on 6.4
by CTSchorsch » Wed, 2019-02-20 11:49
2
by CTSchorsch
Mon, 2020-01-20 07:30
Normal topic low voltage/power VESC
by qdxiatao » Sun, 2019-12-29 09:27
2
by qdxiatao
Mon, 2020-01-06 02:04
Normal topic Red Flashing Light?
by givol » Sat, 2019-06-29 19:01
2
by frank
Sun, 2019-07-21 18:25
Normal topic Where does the 3.3v come from?
by cnd » Sun, 2019-07-21 12:38
2
by cnd
Wed, 2019-07-24 05:47
Normal topic Sailboat Controller/Motor/Generator
by Joe Lorkovic » Thu, 2020-05-28 21:55
2
by Eric Crouch
Sat, 2020-06-06 19:11
Normal topic Firmware flash on new born board
by matrixgti » Thu, 2020-10-08 20:39
2
by TechAUmNu
Tue, 2020-10-13 10:18
Normal topic One remote, two VESCs (wirelessly)?
by fogus » Mon, 2020-10-26 17:42
2
by Rashid1992
Wed, 2020-12-30 08:51
Normal topic HELP set current settings for inverter
by ka_ru » Wed, 2020-11-18 20:51
2
by ka_ru
Mon, 2020-11-23 11:41
Normal topic Inductance measurement ?
by ziumus » Sat, 2019-05-25 21:31
3
by a.dahhak
Wed, 2020-06-03 21:48
Normal topic BitWizard ESC thermal Mod 100A cont.
by Philipp Spindler » Thu, 2018-05-24 16:01
3
by Roger Wolff
Thu, 2018-05-24 18:10
Normal topic Maker X Mini VESC burned at 46V. My fault or shitty quality?
by smileandbeware » Mon, 2019-11-18 10:53
3
by frank
Thu, 2019-12-26 15:27
Normal topic MAYTECH ESC6 200A runs fine on 6s, faults immediately on 12s
by mxpro32 » Sun, 2019-06-30 21:39
3
by TechAUmNu
Tue, 2019-08-13 10:21
Normal topic Motor detection accuracy in 3rd party hardware (old FW vs new FW)
by shaman » Tue, 2020-02-25 16:03
3
by vadicus
Wed, 2020-02-26 19:09
Normal topic copy setup from one vesc to another?
by curtm » Mon, 2019-07-08 20:33
3
by district9prawn
Sat, 2019-07-20 23:44
New posts
No new posts
Hot topic with new posts
Hot topic without new posts
Sticky topic
Locked topic
Subscribe to RSS - Third Party Hardware