You are here
Third Party Hardware
Log in to post new content in the forum.
Topic / Topic starter |
Replies | Last post | |
|---|---|---|---|
|
Modified version of mini4,during motor detection，fault_code_drv-11 was reported by qdxiatao » Mon, 2022-10-31 07:42 |
0 |
by qdxiatao Mon, 2022-10-31 07:42 |
|
|
Mosfet Discussion by WalterWitt » Mon, 2022-04-18 20:38 |
3 |
by vadicus Thu, 2022-04-21 00:01 |
|
|
Motor controller commercial test benches by lopezcontreras » Mon, 2019-12-16 15:31 |
0 |
by lopezcontreras Mon, 2019-12-16 15:31 |
|
|
Motor detection accuracy in 3rd party hardware (old FW vs new FW) by shaman » Tue, 2020-02-25 16:03 |
3 |
by vadicus Wed, 2020-02-26 19:09 |
|
|
Motor is too loud, are there settings to quiet it? by Jason Toews » Thu, 2021-09-23 20:49 |
2 |
by Laurie Forbes Thu, 2021-09-30 18:57 |
|
|
Motor not spinning NO FAULTS by 123seaborder » Mon, 2019-06-10 21:46 |
1 |
by gogglespast Sat, 2019-09-14 08:34 |
|
|
Motor Setup issues e-Snowboard by arosenthal » Fri, 2020-09-18 21:10 |
3 |
by etadada12 Sun, 2020-11-29 02:17 |
|
|
Motor spins only with outside help by asaf123098 » Thu, 2019-04-04 06:52 |
4 |
by dekafive Thu, 2019-06-20 11:36 |
|
|
Motors with known valid configurations by doctarr » Fri, 2021-01-01 14:28 |
4 |
by doctarr Sat, 2021-01-09 14:44 |
|
|
MTVESC 6.12 DRV fault under load by rafchal@yahoo.com » Fri, 2020-11-06 00:21 |
0 |
by rafchal@yahoo.com Fri, 2020-11-06 00:21 |
|
|
Need Help with HI200-C from Maker X by Moritz@liebler.net » Tue, 2021-01-12 14:44 |
4 |
by Oded Mazor Thu, 2022-03-24 12:05 |
|
|
Need IRF7759 by marcel7162 » Fri, 2022-03-18 22:29 |
0 |
by marcel7162 Fri, 2022-03-18 22:29 |
|
|
Need to integrate 4 motor controllers for sensored motors by charlesrwest » Sun, 2021-09-26 20:19 |
1 |
by skyline1970 Fri, 2021-10-29 12:01 |
|
|
Need Your Help with PPM Mapping Remote during Setup by silverglate » Sun, 2019-02-03 05:04 |
33 |
by joelG Wed, 2025-01-29 18:57 |
|
|
Negative Current Issue by uwdxa » Tue, 2019-01-22 01:16 |
1 |
by IanG Tue, 2020-03-17 09:27 |
|
|
New need help by VinnyF » Tue, 2019-12-10 13:16 |
2 |
by tex Wed, 2019-12-11 17:19 |
|
|
No USB connection by Flepple » Sat, 2020-12-12 21:40 |
5 |
by vadicus Thu, 2020-12-17 21:06 |
|
|
Noob....Power profiles on Android vesc tools by tailele » Sun, 2020-09-20 21:48 |
0 |
by tailele Tue, 2020-09-22 09:08 |
|
|
Not able to drive output current by tecmarek » Tue, 2024-12-10 10:49 |
0 |
by tecmarek Tue, 2024-12-10 10:55 |
|
|
Nrf51822 modul by mrendu43 » Wed, 2021-07-07 09:13 |
0 |
by mrendu43 Wed, 2021-07-07 09:13 |
|
|
One remote, two FSESC4.20 (wirelessly)? by fogus » Mon, 2020-10-26 17:42 |
1 |
by Rashid1992 Wed, 2022-08-31 10:32 |
|
|
Phase A not working and GVDD_OV/GVDD_UV DRV faults by chocol4te » Mon, 2019-04-01 15:32 |
0 |
by chocol4te Mon, 2019-04-01 15:32 |
|
|
Phase voltage rise time by CTSchorsch » Wed, 2020-10-07 14:09 |
0 |
by CTSchorsch Wed, 2020-10-07 14:09 |
|
|
Porting VESC firmware to ODrive hardware by Remind » Wed, 2021-06-30 01:39 |
3 |
by vadicus Thu, 2021-07-08 07:34 |
|
|
Power loss after 30seconds. by flyingbrike » Sun, 2020-06-14 22:50 |
0 |
by flyingbrike Sun, 2020-06-14 22:50 |
Log in to post new content in the forum.
