You are here

Third Party Hardware

Topic / Topic starter Replies Last postsort ascending
Normal topic 4.12 Phase current/voltage sense mix up. Need assistance please.
by shaman » Tue, 2019-01-29 14:58
2
by shaman
Tue, 2019-01-29 16:24
Normal topic maytech mto91hbm-nh motors hal sensor
by nolander » Thu, 2019-01-10 00:01
1
by sunsam8
Thu, 2019-01-10 11:15
Normal topic HW4.12 Firmware trouble
by CTSchorsch » Wed, 2018-12-05 21:09
4
by sam.vanratt
Fri, 2018-12-28 17:55
Normal topic Custom VESC4.8 short circuit error
by b4zz » Mon, 2018-12-17 10:26
4
by b4zz
Wed, 2018-12-19 16:48
Normal topic Cheap VESC (VESC 4.12 redesign)
by shaman » Sun, 2018-12-09 16:16
7
by shaman
Tue, 2018-12-18 21:48
Normal topic Stream realtime data stops streaming
by b.visser@studen... » Fri, 2018-09-14 16:09
1
by thewho
Thu, 2018-12-13 21:27
Normal topic How to upload firmware on MINI4 ?
by john » Mon, 2018-11-12 10:55
1
by john
Mon, 2018-11-12 11:59
Normal topic Driving 2 BLDC motors with one MCU
by Pimousse » Tue, 2018-06-26 15:42
13
by wkt
Wed, 2018-10-17 14:02
Hot topic SDRV - Dual 6.4 HW PCB
by josh » Wed, 2018-03-07 07:39
42
by TechAUmNu
Mon, 2018-10-15 22:04
Normal topic Maytech VESC duty cycle & PID control problems
by subodh.malgonde » Mon, 2018-10-01 11:49
1
by subodh.malgonde
Tue, 2018-10-02 11:59
Normal topic Maytech VESC 4.10 UART issues
by LogixCraft » Tue, 2018-09-25 03:13
0
by LogixCraft
Tue, 2018-09-25 03:13
Normal topic Maytech VESC keeps startup spinning slowly
by Snorreman » Mon, 2018-09-24 09:57
0
by Snorreman
Mon, 2018-09-24 09:57
Normal topic Custom 12S VESC seems to be power limiting or something
by nickw1881 » Sat, 2018-08-25 07:40
4
by nickw1881
Tue, 2018-09-18 05:56
Normal topic Maytech esc 5V rail reads 0.5v
by hhhhghg » Fri, 2018-09-14 13:23
0
by hhhhghg
Fri, 2018-09-14 13:23
Normal topic Flipsky 4.12 Vesc in FOC mode?
by Jonny254 » Sat, 2018-09-08 11:25
3
by Jonny254
Thu, 2018-09-13 05:48
Normal topic VESC without Shunt Resistors/FOC
by tul00985 » Mon, 2018-06-11 13:27
14
by tul00985
Mon, 2018-09-10 08:36
Normal topic Uploaded the wrong firmware, now I need help to debug :P
by Frazatto » Tue, 2018-08-21 15:46
12
by Frazatto
Tue, 2018-09-04 19:33
Normal topic VESC 6 With AS5047 encoder
by Geir Henriksen » Tue, 2018-07-31 00:09
2
by frank
Mon, 2018-08-20 09:32
Normal topic External power-side board
by HansPeterHaastrup » Mon, 2018-07-30 14:53
5
by HansPeterHaastrup
Mon, 2018-07-30 18:23
Normal topic HW advice : repair , vesc 4.12, vesc 6.4 or better wait ?
by frameto » Sun, 2017-11-19 21:36
1
by josh
Thu, 2018-07-26 18:47
Normal topic Information about "Das RS" and "Das mini" hardware using DRV8313/DRV8320
by hexakopter » Thu, 2018-04-26 19:18
3
by hexakopter
Wed, 2018-06-13 00:39
Normal topic BitWizard ESC thermal Mod 100A cont.
by Philipp Spindler » Thu, 2018-05-24 16:01
3
by Roger Wolff
Thu, 2018-05-24 18:10
Normal topic 84v VESC??
by larsrocket » Sun, 2018-04-01 22:41
1
by larsrocket
Mon, 2018-04-30 19:59
Normal topic Low power VESC - any available
by wdaehn » Wed, 2018-02-28 18:02
9
by TechAUmNu
Mon, 2018-03-19 11:54
Normal topic DIY Vesc 6 issues with motor detection
by roxes1 » Sun, 2017-11-12 10:15
1
by roxes1
Sun, 2018-02-11 07:23
New posts
No new posts
Hot topic with new posts
Hot topic without new posts
Sticky topic
Locked topic
Subscribe to RSS - Third Party Hardware