You are here
General discussion
Log in to post new content in the forum.
Topic / Topic starter |
Replies | Last post | |
|---|---|---|---|
|
Would like VESC 4.12 repair tips by spork » Wed, 2019-04-03 04:53 |
6 |
by spork Tue, 2019-04-23 11:01 |
|
|
Wow wow by st0r » Sat, 2022-05-07 21:45 |
2 |
by Hansherrman Sun, 2022-10-30 01:40 |
|
|
Wrong CAN termination resistor? by DarioP » Mon, 2022-06-13 21:27 |
3 |
by frank Thu, 2022-06-16 08:33 |
|
|
ws8212 and VESC firmware by dannlh » Fri, 2017-11-03 04:17 |
2 |
by dannlh Sat, 2017-11-04 18:47 |
|
|
Xiaomi m365 mega upgrade by Tilman Baumann » Mon, 2018-02-12 12:25 |
47 |
by Grawp Wed, 2021-03-10 13:59 |
|
|
Your input needed: FESC 4.12 / Arduino / 4X 350W motors by matukash » Tue, 2020-07-21 16:36 |
6 |
by frank Fri, 2022-04-15 17:31 |
|
|
[OT] Increase torque on DC brush motor by Riccio » Mon, 2022-03-28 19:32 |
2 |
by Riccio Tue, 2022-03-29 09:18 |
|
|
[SOLVED, was a mistake] Set ERPM command: issue with the speed controller with higher speed values that is possible with bat vol by yes_wecangogreen » Wed, 2023-04-12 00:51 |
1 |
by yes_wecangogreen Sat, 2023-04-29 09:24 |
|
|
[SOLVED] PWM speed control at low RPM by comes04 » Sun, 2023-04-16 13:30 |
1 |
by comes04 Wed, 2023-05-03 20:44 |
|
|
[Solved]Command the throttle (ADC1) with a DAC by captaintoon » Sat, 2024-01-27 23:41 |
3 |
by captaintoon Sun, 2024-01-28 15:44 |
|
|
[SOLVED]Motors "blocking totally" when throttling, after running VESC setup. by MaddiQ » Tue, 2018-06-12 21:01 |
0 |
by MaddiQ Tue, 2018-06-12 23:36 |
Log in to post new content in the forum.
