You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter | Replies |
Last post |
|
|---|---|---|---|
|
Issues with throttle range translating to duty by Elliot Kingsley » Thu, 2025-10-16 02:40 |
1 |
by cwk1234 Tue, 2025-10-21 02:22 |
|
|
Hall sensor port repeatedly fried on original hardware by Rc 44 » Fri, 2025-10-24 22:44 |
0 |
by Rc 44 Fri, 2025-10-24 22:44 |
|
|
vesctool 6.06 for Mac? by gregd72002 » Sat, 2025-09-27 03:36 |
3 |
by electricfox Sat, 2025-10-25 21:34 |
|
|
VESC App - Android - "App not installed" error by KColborne » Mon, 2023-03-27 22:11 |
1 |
by Valopallo Sun, 2025-10-26 14:29 |
|
|
Vesc boost charging with external inductors by Bunda » Wed, 2025-10-29 08:37 |
0 |
by Bunda Wed, 2025-10-29 08:38 |
|
|
PAS with variable assist+regen brake by Lukas_T » Fri, 2025-08-29 18:05 |
2 |
by Lukas_T Fri, 2025-10-31 10:28 |
|
|
VESC to spin motor after power up? by A_Baum92881 » Fri, 2025-10-31 06:01 |
0 |
by A_Baum92881 Fri, 2025-10-31 17:21 |
|
|
wont gonnect by rustman01 » Wed, 2025-11-05 19:26 |
0 |
by rustman01 Wed, 2025-11-05 19:26 |
|
|
Vesc Orientation Python by flomai28 » Mon, 2025-11-10 09:44 |
0 |
by flomai28 Mon, 2025-11-10 09:44 |
|
|
FOC detection. by Roger Wolff » Tue, 2025-10-21 19:57 |
1 |
by tobiokanobi Sat, 2025-11-15 21:02 |
|
|
Motor stopped and I had to run Setup Motors FOC wizard to get it going again by JasonBear » Fri, 2025-11-14 13:24 |
2 |
by JasonBear Sun, 2025-11-16 20:41 |
|
|
Running motors under 900ERPM in speed control by Chieflouis01 » Thu, 2025-11-27 21:32 |
2 |
by Chieflouis01 Thu, 2025-11-27 21:33 |
Log in to post new content in the forum.
