You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Autonomous RC car with Focbox suddenly stops by Autocar » Mon, 2021-12-06 06:55 |
0 |
by Autocar Mon, 2021-12-06 06:55 |
|
|
Read telemetry data from USB port by mlsc » Sun, 2024-10-06 22:01 |
0 |
by mlsc Sun, 2024-10-06 22:01 |
|
|
Setting RPM over UART by klay2000 » Sat, 2024-06-29 01:27 |
0 |
by klay2000 Sat, 2024-06-29 01:28 |
|
|
dual vesc question by badger1666 » Sun, 2018-10-28 12:59 |
0 |
by badger1666 Sun, 2018-10-28 12:59 |
|
|
Current control performance & best way to tune Kp and Ki by jinwonchung » Thu, 2024-10-17 15:52 |
0 |
by jinwonchung Thu, 2024-10-17 15:53 |
|
|
How to use an IMU and a PPM remote parallel by Gos1 » Tue, 2022-10-25 15:28 |
0 |
by Gos1 Wed, 2022-10-26 10:57 |
|
|
Maximize startup torque by arosenthal » Sat, 2020-11-14 14:16 |
0 |
by arosenthal Sat, 2020-11-14 14:17 |
|
|
Cannot connect to VESC via USB or SWD by hagis » Wed, 2020-09-23 17:21 |
0 |
by hagis Wed, 2020-09-23 17:21 |
|
|
Issue with VESC I/O on donkey car by baluja » Fri, 2022-10-28 02:56 |
0 |
by baluja Fri, 2022-10-28 02:56 |
|
|
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere » Fri, 2022-10-28 21:02 |
0 |
by sivanhere Fri, 2022-10-28 21:02 |
|
|
Voltage spikes on BEMF scope by Sgw32 » Wed, 2020-11-18 16:03 |
0 |
by Sgw32 Wed, 2020-11-18 16:06 |
|
|
What do i need? by Robert Thomas » Fri, 2022-09-16 21:39 |
0 |
by Robert Thomas Fri, 2022-09-16 22:12 |
|
|
Does PLL measure the REAL motor speed by wyk » Mon, 2020-11-23 08:34 |
0 |
by wyk Mon, 2020-11-23 08:34 |
|
|
HFI Tuning - "Start Voltage" Question by drummerboy5408 » Sat, 2022-11-12 03:12 |
0 |
by drummerboy5408 Sat, 2022-11-12 03:12 |
|
|
VESC - Motor will not start until a small kick is applied from a full stop despite using hall sensors by 010203040506070809 » Wed, 2019-10-23 23:12 |
0 |
by 010203040506070809 Wed, 2019-10-23 23:12 |
|
|
Flipsky 75100 — can LispBM actually receive custom data from an ESP32 over UART? event-data-rx never fires by Philippe Larouche » Fri, 2026-06-26 15:13 |
0 |
by Philippe Larouche Fri, 2026-06-26 15:13 |
|
|
Rion Tronic 250/ Focer3.1 using TC leads to explosion! by Drcfan » Mon, 2022-11-14 23:12 |
0 |
by Drcfan Tue, 2022-11-15 14:05 |
|
|
75200 over voltage fault with 80100 outrunner by PProni » Tue, 2026-06-30 17:27 |
0 |
by PProni Tue, 2026-06-30 17:27 |
|
|
VESC packet fram-size by Yosh101 » Fri, 2022-09-30 15:34 |
0 |
by Yosh101 Fri, 2022-09-30 15:34 |
|
|
PID Thermal Rollback Proposal by Selone » Thu, 2026-07-23 00:14 |
0 |
by Selone Thu, 2026-07-23 01:53 |
|
|
Install VESC on ubuntu 18.04 bionic by rest_vesc_001 » Tue, 2020-12-08 15:34 |
0 |
by rest_vesc_001 Tue, 2020-12-08 15:34 |
|
|
Trouble Detecting ABI Encoder on VESC6/75 by jonathansel » Fri, 2022-10-07 22:34 |
0 |
by jonathansel Fri, 2022-10-07 22:34 |
|
|
Help needed in controlling multiple VESC boards (multiple motors) with VESC ROS (need to debug errors) by shreyas.srinivasan » Thu, 2022-10-13 08:13 |
0 |
by shreyas.srinivasan Thu, 2022-10-13 08:13 |
|
|
Vesc gps control by Erik » Thu, 2019-11-14 20:38 |
0 |
by Erik Thu, 2019-11-14 20:38 |
|
|
VESC 6 EDU: Motor Wizard - Detection failed by Navigator_PJE » Mon, 2022-08-29 16:12 |
0 |
by Navigator_PJE Mon, 2022-08-29 16:12 |
Log in to post new content in the forum.
