You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Motor only running in reverse by obex_mike » Mon, 2018-06-25 16:25 |
2 |
by frank Tue, 2018-06-26 12:36 |
|
|
vesc for autonomous robots by _saeed_arabi_ » Tue, 2019-10-15 00:25 |
2 |
by Mayank Wed, 2023-06-07 00:05 |
|
|
Can I measure a 1.5 KW AC Servo with VESC Tool by Don_Karlos » Sun, 2024-05-26 21:28 |
2 |
by adilrepas Mon, 2024-08-05 18:54 |
|
|
IPM/Salient Motor Tuning by SRFirefox » Wed, 2020-08-26 23:19 |
2 |
by JP Wed, 2022-08-17 11:22 |
|
|
Reprogram VESC for sensorless motor by Christopherinco... » Thu, 2020-09-03 00:10 |
2 |
by vadicus Thu, 2020-09-03 01:14 |
|
|
PAS with variable assist+regen brake by Lukas_T » Fri, 2025-08-29 18:05 |
2 |
by Lukas_T Fri, 2025-10-31 10:28 |
|
|
Flipsky motor and flipsky FSESC, can't move when weighted/under load. by adamgil801 » Fri, 2022-07-01 23:17 |
2 |
by Indy8976 Mon, 2022-07-11 11:21 |
|
|
Motor Overheating in FOC by amanpereira1 » Thu, 2022-05-05 16:14 |
2 |
by Nuppen Wed, 2024-02-14 08:14 |
|
|
Real RPM=0 but ERPM>0 issue by cir7 » Tue, 2022-07-12 20:17 |
2 |
by cir7 Wed, 2022-07-13 11:43 |
|
|
Type of motors supported by VESC 6 MKIV by Sami Sahli » Thu, 2020-06-25 11:57 |
2 |
by Samuelx Tue, 2021-08-17 20:24 |
|
|
Rc controller more than one input ? by zebb.guy@moshon... » Tue, 2022-07-26 14:51 |
2 |
by zebb.guy@moshon... Wed, 2022-07-27 17:22 |
|
|
Battery power by bryncjones » Mon, 2020-08-17 15:35 |
2 |
by TheFallen Tue, 2020-08-18 11:46 |
|
|
Under rated VESC for motor, problem? by Alistair Goodman » Wed, 2022-08-03 12:53 |
2 |
by Alistair Goodman Wed, 2022-08-03 15:27 |
|
|
Gyro/Accel utilisation for built in Alarm ?! :D by yoodog » Tue, 2021-03-30 00:48 |
2 |
by yoodog Tue, 2021-03-30 01:07 |
|
|
Motor is "pumping" under load in current control mode. is this normal? by etienne » Sat, 2023-05-13 17:16 |
2 |
by iv.kravchenko Sat, 2023-05-20 08:31 |
|
|
Update FW on multiple VESC pcbs using CAN issue by Offline » Wed, 2021-05-19 15:07 |
2 |
by Offline Wed, 2021-05-26 08:23 |
|
|
4wd rover using hub-motors by mhyer » Thu, 2023-05-18 09:56 |
2 |
by velolac Tue, 2023-05-23 10:03 |
|
|
ws8212 and VESC firmware by dannlh » Fri, 2017-11-03 04:17 |
2 |
by dannlh Sat, 2017-11-04 18:47 |
|
|
Vedder forums or Vesc forums? by Eric » Wed, 2017-09-13 14:39 |
2 |
by frank Mon, 2017-09-18 10:12 |
|
|
How can I make status packet, using arduino? by Medist » Thu, 2023-06-01 07:33 |
2 |
by toboli Thu, 2023-06-01 23:06 |
|
|
Reverse polarity with 12V battery on Vesc 6, now giving fault codes by Kokonenen » Tue, 2023-03-28 13:45 |
2 |
by frank Wed, 2023-03-29 09:56 |
|
|
Help rc car bldc configuration vesc 4.20 by Katt » Sun, 2021-04-18 15:25 |
2 |
by spacewalker Tue, 2021-05-11 13:01 |
|
|
Can I use 12V power supply? by ryde6 » Sun, 2021-04-25 08:19 |
2 |
by vadicus Wed, 2021-07-14 21:01 |
|
|
Can bus and Arduino by Snabelost » Wed, 2023-06-14 10:30 |
2 |
by Snabelost Thu, 2023-06-15 08:37 |
|
|
limits to reprogramming VESCs by wjpremerlani » Wed, 2023-06-21 09:11 |
2 |
by wjpremerlani Thu, 2023-06-22 20:13 |
Log in to post new content in the forum.
